Buffing
Best used on any surface prepared by sanding to 220x or more and sealed by a penetrating oil finish (tung oil sealer is ideal). Using the all-linen buff and Tripoli bar, perform the initial buffing. Follow this with the white diamond bar on the combination linen/flannel buff to further refine and polish the finish, then complete the process with carnauba wax and the all-flannel buff. The resulting finish is close to a multi-coat lacquer in appearance yet it is achieved in minutes. Although scratches are removed, crisp detail is not softened.
The system is available in four basic variants:
- An 8" wheel kit (for 1725 rpm minimum; 3000 rpm maximum)
- A 4" wheel kit (for 1725 rpm minimum, including 3450 rpm motors)
- A lathe mandrel kit
- Three sizes of bowl buffs
Buffing
This Image has not been loaded yet, close the print view and wait for the images to load and try again.
The 8" Beall Buffing System
This Image has not been loaded yet, close the print view and wait for the images to load and try again.
The 4" Beall Buffing System
This Image has not been loaded yet, close the print view and wait for the images to load and try again.
Beall 3-On Lathe Buffing System
This Image has not been loaded yet, close the print view and wait for the images to load and try again.
Beall 2" Bowl Buff Set
This Image has not been loaded yet, close the print view and wait for the images to load and try again.
Beall 3" Bowl Buff Set
This Image has not been loaded yet, close the print view and wait for the images to load and try again.
Beall 4" Bowl Buff Set
This Image has not been loaded yet, close the print view and wait for the images to load and try again.
Beall Morse Taper Mandrels
This Image has not been loaded yet, close the print view and wait for the images to load and try again.
Combination Adapter for Beall Bowl Buf...
This Image has not been loaded yet, close the print view and wait for the images to load and try again.
Combination Adapter Extension for Beal...
This Image has not been loaded yet, close the print view and wait for the images to load and try again.
Replacement Buffs for 8" Beall Buffing...
This Image has not been loaded yet, close the print view and wait for the images to load and try again.
8" Replacement Buffs for Beall 3-On La...
This Image has not been loaded yet, close the print view and wait for the images to load and try again.
4" Replacement Buffs for Motors
This Image has not been loaded yet, close the print view and wait for the images to load and try again.