Options:
Model
Variations:
- 05J0601 - Basic System
- 05J0602 - Deluxe System
Veritas 32 Cabinetmaking System
- All holes are measured with consistent 32mm spacing and all in reference to panel sides and ends
- Gauge head has both metric and Imperial graduations (recommend using metric for design and construction stage to reduce rounding errors)
- Set drilling rails 37mm in from panel edge and clamp into place; system holes (vertical holes for screws, inserts, shelf supports or hinges) and construction holes (horizontal holes bored to accept dowels) can then be drilled
- Bush carrier straddles rail, with selected size of drill bushing in hole in rail where first hole is to be drilled; holes then drilled as required for design
- Dowelling jig bases allow for drilling dowel holes in ends of top and bottom panels
- Two systems are offered – basic jig and deluxe system
- Basic system includes one rail with fixing screws, two regular-length rods (for work up to 12" wide), two clamp heads and two tails, a bush carrier with 5, 8 and 10mm bushings, a 3/32" hex key and a register pin (see chart below for components that can be added to this system)
- Deluxe system includes all items in basic system, plus two extra rails, two long rods (for work up to 24" wide), a gauge head, dowelling jig bases, connector rods and plate, and an extra register pin
- Included detailed instruction booklet is also available separately
- Made in Canada
- Patented
Product # | Description |
05J06.01 | Veritas® 32 Basic Cabinetmaking System |
05J06.02 | Veritas® 32 Deluxe Cabinetmaking System |
05J06.00 | Instruction Booklet |