All holes are measured with consistent 32mm spacing and all in reference to panel sides and ends
Gauge head has both metric and Imperial graduations (recommend using metric for design and construction stage to reduce rounding errors)
Set drilling rails 37mm in from panel edge and clamp into place; system holes (vertical holes for screws, inserts, shelf supports or hinges) and construction holes (horizontal holes bored to accept dowels) can then be drilled
Bush carrier straddles rail, with selected size of drill bushing in hole in rail where first hole is to be drilled; holes then drilled as required for design
Dowelling jig bases allow for drilling dowel holes in ends of top and bottom panels
Two systems are offered – basic jig and deluxe system
Basic system includes one rail with fixing screws, two regular-length rods (for work up to 12" wide), two clamp heads and two tails, a bush carrier with 5, 8 and 10mm bushings, a 3/32" hex key and a register pin (see chart below for components that can be added to this system)
Deluxe system includes all items in basic system, plus two extra rails, two long rods (for work up to 24" wide), a gauge head, dowelling jig bases, connector rods and plate, an extra register pin, plus a fitted wooden box to store all parts (except rails and long rods)
Included detailed instruction booklet is also available separately