Skip to contentAccessibility Statement
ITEM ADDED TO YOUR CART ()
logologo
Registering a 1 1/2"" Pocket Layout Square against the edge of a workpiece while marking a cut line
Using a Veritas 1 1/2"" Pocket Layout Square over a tape measure to strike a line on a workpiece
Using a Veritas 1 1/2"" Pocket Layout Square to measure a small hinge leaf
Using a 1 1/2"" Pocket Layout Square and a striking knife to mark out a hinge gain on a workpiece
Using the protractor scale marked on a 1 1/2"" Pocket Layout Square to lay out an angled cut line
Using the 1/4"" side of the 1 1/2"" Pocket Square’s base to mark out a mortise centered on 3/4"" stock
A woodworker slips a Veritas 1 1/2"" Pocket Layout Square into the pocket of a workshop apron
05N5410 - Veritas 1 1/2"" Pocket Layout Square
05N5410 - Veritas 1 1/2"" Pocket Layout Square
Registering a 1 1/2"" Pocket Layout Square against the edge of a workpiece while marking a cut line
Using a Veritas 1 1/2"" Pocket Layout Square over a tape measure to strike a line on a workpiece
Using a Veritas 1 1/2"" Pocket Layout Square to measure a small hinge leaf
Using a 1 1/2"" Pocket Layout Square and a striking knife to mark out a hinge gain on a workpiece
Using the protractor scale marked on a 1 1/2"" Pocket Layout Square to lay out an angled cut line
Using the 1/4"" side of the 1 1/2"" Pocket Square’s base to mark out a mortise centered on 3/4"" stock
A woodworker slips a Veritas 1 1/2"" Pocket Layout Square into the pocket of a workshop apron
05N5410 - Veritas 1 1/2"" Pocket Layout Square
05N5410 - Veritas 1 1/2"" Pocket Layout Square

Veritas 1 1/2" Pocket Layout SquareMade in Canada

Dealer Information

  • This triangular layout square is only 1-1/2" on a side
  • The 1/2" wide by 1/8" thick base registers solidly against a workpiece and has a 1/8" offset on one edge and 1/4" on the other
  • Anodized and laser etched on both sides
  • 1/16" rule graduations and angle graduations in 10° increments
  • Machined from solid aluminum extrusion
  • Made in Canada
    • Product #Description
    05N54.10Veritas® 1-1/2" Pocket Layout Square
Registering a 1 1/2"" Pocket Layout Square against the edge of a workpiece while marking a cut line

Options:

Variations:

  • 05N5410 - Veritas 1 1/2" Pocket Layout Square
    1 - $12.50

Veritas 1 1/2" Pocket Layout Square

  • This triangular layout square is only 1-1/2" on a side
  • The 1/2" wide by 1/8" thick base registers solidly against a workpiece and has a 1/8" offset on one edge and 1/4" on the other
  • Anodized and laser etched on both sides
  • 1/16" rule graduations and angle graduations in 10° increments
  • Machined from solid aluminum extrusion
  • Made in Canada
    • Product #Description
    05N54.10Veritas® 1-1/2" Pocket Layout Square